Service · Installation

Tankless Water Heater Installation

Endless hot water from a unit the size of a carry-on suitcase. We install AO Smith tankless water heaters across Bloomington, sized to your fixtures, vented correctly, and tuned so the shower never goes cold, even with laundry running.

Call (812) 558-9199 Get a free estimate

Sized to your house, not a brochure

A tankless unit is rated in gallons per minute, and the right size depends on how many fixtures run at once and how cold Indiana groundwater gets in January, colder inlet water means more burner needed per gallon. We count your fixtures, check your winter inlet temperature, and spec the unit that keeps two showers and a dishwasher happy at the same time.

The install is the whole job

A tankless heater is only as good as its gas supply and venting. Most Bloomington homes need the gas line upsized to feed a 150,000+ BTU burner, and condensing units need dedicated PVC venting and a condensate drain. All of that is in our quote from the start, the number won’t grow once we open the wall.

What you get back

Floor space where the tank stood, roughly 20–30% off water-heating energy since nothing sits hot all night, and a unit that runs 20+ years with annual descaling instead of a tank’s 10–12. Bloomington’s moderately hard water makes the annual flush worth doing, we offer it as a quick service visit.

What's included

+AO Smith condensing tankless unit
+Gas line sizing and upgrade included in quote
+Dedicated venting and condensate drain
+Isolation valves for easy annual flushing
+Monroe County permit and inspection scheduling
+Labor warranty plus AO Smith heat-exchanger warranty
Wall-hung tankless water heater unit
Typical installed price

$4,500 – $6,000

Condensing tankless unit, installed with proper venting and gas sizing. Exact price depends on your gas line and vent run.

Call for an exact quote
Common questions

Is tankless really endless hot water?

Yes, within its flow rating, it heats water as it passes, so it never runs out. Undersize it and two showers will feel it; that’s why sizing is the whole game.

How long does the install take?

A new tankless installation is typically four to six hours. If we’re also removing a tank and rerouting gas and venting, plan on a full day, see our conversion page.

What maintenance does it need?

An annual descaling flush, about 45 minutes through the isolation valves we install. Skip it for years and Bloomington’s hard water will shorten the heat exchanger’s life.

Will it work when the power is out?

No, gas tankless units need electricity for ignition and controls, same as a modern gas tank with power venting. A small battery backup can cover ignition if outages worry you.

Never schedule showers around laundry again

Same-day service across Bloomington · exact quote in one call

Call (812) 558-9199